2500 Leg Spacer (10mm)

N° de pièce: RLKS1

The RLKS1 spacer blocks are used to level a 3 bar roof rack system on a vehicle such as a pickup that may have rear posts or a cap/topper rack system. Attached between the Rhino-Rack 2500 leg and either a Rhino-Rack Heavy Duty or Vortex cross bar, this set of spacers will raise the cross bar 10mm in height.

Détails du produit

Vue d’ensemble

These leg height spacers have been designed for use on a support bar, set up for long loads - they are not to be used as a 2 bar system under a load bearing cross bar. Made from glass re-enforced nylon, just like our legs, they are strong and flexible.

All necessary hardware is supplied. The maximum height stacking that is recommended by Rhino-Rack Rack is 42mm. If you need to go higher, please use the JB Spacer / Height Adjustor (RLK2500HALF-JB).

This kit includes:

  • 2 x 10mm Spacer Blocks
  • 2 x M6 x 32mm Bolts
Garantie
5 ans
Vortex - Compatible
Heavy Duty - Compatible

Vue d’ensemble

These leg height spacers have been designed for use on a support bar, set up for long loads - they are not to be used as a 2 bar system under a load bearing cross bar. Made from glass re-enforced nylon, just like our legs, they are strong and flexible.

All necessary hardware is supplied. The maximum height stacking that is recommended by Rhino-Rack Rack is 42mm. If you need to go higher, please use the JB Spacer / Height Adjustor (RLK2500HALF-JB).

This kit includes:

  • 2 x 10mm Spacer Blocks
  • 2 x M6 x 32mm Bolts
Package length
7.48 inch
Package width
3.94 inch
Package height
1.97 inch
Garantie
5 ans
Pays d'origine
Australia
Vortex - Compatible
Heavy Duty - Compatible